The new Side-Power designer radio remote control is the coolest addition to thruster controls. This is a plug-and-play addition to any existing Side-Power thruster system allowing more functional use of the equipment. Focused on user-friendliness by ensuring optimal ergonomics, ease of use and a high safety level. It retrofits easily with Side-Power thruster systems and most windlasses. A key feature is the clear boat shape in the design, eliminating the chance of misunderstanding directions when moving freely on boat. It incorporates the Side-Power unique safety features protecting against unintended activation of thrusters. Illuminated buttons with soft lighting makes use of the remote at night convenient - and it comes with both a snapin holder and a neck strap with snap-off safety. The new shape of the remote and locking holder enables trouble free operation of the remote whilst in the holder - it doubles up as an additional fixed control station. The new radio remote control is waterproof, has large rubber buttons and the defined ridges between the buttons makes it easy to use without looking. Rubber pads on the back prevents it from sliding around, leaving scratches on polished surfaces.
- Backlit buttons when activated
- Boat shaped design and button layout makes control intuitive to operate
- New locking holder enables use as a secondary fixed control station
- Neck strap with quick release buckle
- Ergonomic shape fits nicely in hand
- Waterproof IP65 and will float
- Friction rubber pads on back so it will not move or mark consoles
- Automatic deactivation after approximately 4 min of inactivity
- Up to 4 remotes per receiver
- Unique transmitter codes, secures against activation from other than programmed Side-Power remotes
- The receiver is in standby mode unless activated by the programmed Side-Power remote
- When pushing the off button, the remote sends an off signal to the receiver or if you forget, the remote will automatically de-activate 3 min after last use
- Even without an off signal, the receiver will go into standby mode 4 min after last use
- Requires 2 standard CR2032 (Imtra #SMCR2032) batteries which can be purchased wherever utility batteries are sold
- Includes: Transmitter
- Maximum Range: 50 to 80m
- Multiplexing: Allows Simultaneous use of Bow and Stern Thrusters
- Security: Transmitter Codes Prevent Unwanted Activation
- 9 to 28 Volts